More pour logo

01293 862382

How to install a beer tap onto a flash cooler

July 1, 2018
October 25, 2019

Attached is a simple drawing to show a very basic installation of a single beer tap through a flash cooler. Links to some of the required parts listed below.

1 - Gas Bottle (From your local supplier)

2 - Keg (Choice of keg from your local supplier)

3 - Keg coupler (Make sure that you get the correct connector for the beer that you will be using)

4 - Gas primary regulator

5 - Secondary gas regulator

6 - Fob detector

7 - Flash cooler

8 - Insulated pipe

9 - Flow controller

10 - Font and tap

You would also require 1x John Guest 3/8 plug fitting for the side of the secondary regulator, 2x 3/8 John Guest equal elbow fittings for the attachment to the flash cooler.

Also, the required product and gas pipe can be found here https://www.morepour.com/shop?store-page=Pipework-c23911532

Back to Blogs
TECHNICIAN'S PORTAL