How to install a draught beer tap guide
Attached is a simple drawing to show a very basic installation of a single beer tap through a flash cooler. Links to some of the required parts listed below.
- Gas Bottle (From your local supplier)
- Keg (Choice of keg from your local supplier)
- Keg coupler (Make sure that you get the correct connector for the beer that you will be using)
- Gas primary regulator
- Secondary gas regulator
- Fob detector
- Flash cooler
- Insulated pipe
- Flow controller
- Font and tap
You would also require 1 x John Guest 3/8 plug fitting for the side of the secondary regulator, 2 x 3/8 John Guest equal elbow fittings for the attachment to the flash cooler. Also, the required product and gas pipe can be found HERE.